We have compiled a list of manufacturers, distributors, product information, reference prices, and rankings for Bus Analyzer.
ipros is IPROS GMS ・ IPROS One of the largest technical database sites in Japan that collects information on.

Bus Analyzer×ラインアイ - List of Manufacturers, Suppliers, Companies and Products

Bus Analyzer Product List

1～2 item / All 2 items

Displayed results
TTL, I2C, SPI Bus Analyzer (LE-8200 type)

TTL, I2C, SPI Bus Analyzer (LE-8200 type)

Optimal for measuring TTL, I2C, and SPI.

The OP-SB85L is an interface expansion set equipped with a communication measurement port for TTL/C-MOS signal levels and a high-speed analog measurement port. The TTL/C-MOS measurement port supports a wide voltage range of TTL/C-MOS level communication from 1.8V power systems to 5V power systems, making it ideal for directly probing communication lines, such as between communication LSI and interface IC on printed circuit boards, to observe and test communication status. It can measure not only general UART and HDLC communications but also monitor and simulate I2C/SPI. Additionally, a burst measurement mode that captures all data synchronized with the clock signal is also available.

  • Testing Equipment and Devices
  • Image Processing Equipment
  • Other measurement, recording and measuring instruments

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration
CAN and LIN Bus Analyzer (LE-8200 type)

CAN and LIN Bus Analyzer (LE-8200 type)

Ideal for evaluating communication networks that mix CAN and LIN.

The measurement port is equipped with 2 channels, allowing you to switch between ISO11898 (High Speed) and ISO11519-2 (Low Speed) for each port. Of course, it supports both standard format (11bit ID) and extended format (29bit ID). Measurement data is recorded simultaneously with a timestamp in 1ms increments, making it easy to detect the timing of faults. The simulation function allows you to send data frames and remote frames with a single touch. Additionally, you can send data while sequentially changing values to the specified settings within a designated time. Utilizing these features significantly improves the efficiency of developing CAN bus devices and DeviceNet devices. <Components> Dedicated expansion board, line state display sheet B, 2 DB9 monitor cables, 2 three-wire probe cables, 8-wire probe cable.

  • Testing Equipment and Devices
  • Image Processing Equipment
  • Other measurement, recording and measuring instruments

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration
COPYRIGHT © 2001-2025 IPROS CORPORATION ALL RIGHTS RESERVED.